Drilling jig for cam lock connectors.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple jig for cam lock connector holes, featuring an edge-distance stop.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 141
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple jig for cam lock connector holes, featuring an edge-distance stop.
Cam nut hole:
- diameter: 15 mm
- distance from material edge: 34 mm
For the bushing, I used an 18/15 mm copper pipe reducer; its inner diameter fits a 15 mm router bit perfectly. I cut off the section intended for the 18 mm pipe.
The hole for the bushing in the model can be easily adjusted to your specific dimensions by changing the value of the H34 variable in the FCStd file.
Dowel holes:
- diameter: 8 mm
- spacing: 32 mm
For the bushings, I used the inner races from 608 bearings, which have an 8 mm inner diameter.
The holes for the bushings in the model can be easily adjusted to your specific dimensions by changing the value of the H8 variable in the FCStd file.
To ensure consistent distances from the side edge of the material (ranging from 65 mm to 12 mm), you can use a small sliding rail that moves within a dedicated slot. The rail fits tightly enough that a locking mechanism shouldn't be necessary; however, should the parts wear over time, you can install an M3 threaded insert in the rail and lock it in place with a screw.
Enjoy :)