Strengthened-Bucket-Mount for Hydroponic Tower
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reinforced hydroponic tower bucket mount with a wider, thicker rim and six matching bolt holes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 8
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
The original tower connection has been preserved so it remains compatible with the existing tower modules. The mounting rim has been extended outward by approximately ¼ inch and slightly thickened to distribute the tower’s weight across a larger area. The original oversized power-cord opening was replaced with a sixth matching 14 mm bolt hole, creating an evenly spaced six-bolt mounting pattern.
For best results, use stainless-steel bolts with wide washers on the underside of the lid. Tighten the bolts evenly and avoid overtightening, which could deform or crack a plastic bucket lid.
Recommended print settings:
Filament: PETG recommended for water resistance and outdoor durability
Alternative: ASA for better UV and heat resistance
PLA/PLA+: Suitable mainly for indoor or shaded installations
Layer height: 0.20–0.28 mm
Walls: 5–6 perimeters
Top and bottom layers: 6–8
Infill: 40–50% gyroid or cubic
Supports: Normally not required
Orientation: Print flat with the broad mounting flange on the build plate
AI helped my make the changes but I have printed and tested this and it works great.