Gardiner Xtreme pole section Adapter (1-3)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Makes section 1 (21mm) fit into to section 4. Useful for reusing non broken pole-sections and leave broken sections out.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 54
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
You can fit this on on a Xtreme pole from Gardiner on section 1. Keep section 2 and 3 out. The ‘adapter’ fits perfectly around Section 1 and clamps securely inside Section 4.
It is useful if your old pole has broken on section 2 and 3, but you want to keep and reuse the remaining non-broken sections. Using this design you will need to 'skip' section 2 and 3.
I used this setup to create a lightweight short pole for cleaning windows at ground level. Section 4 has a comfortable diameter, giving you a good grip and making the pole easy to handle.
I printed it in PLA with 0.2 mm layers, 0,4 nozzle, 25% infill.
Note: Gardiner SLX uses slightly bigger diameter 21,8mm / 22mm: it won't fit. I will upload a different version for it soon.
Fitting Instructions:
Before fitting the ring, make sure there are no burrs on the inside of the printed ring. If necessary, lightly sand the inside with a piece of sandpaper.
The ring is designed to fit very tightly around the end of Section 1. If the middle part of the pole is slightly thinner, use a few rounds of tape around the pole to make the ring clamp firmly in place.
Use at least three ring adapters. Use four or more if you want to be able to clamp the pole in the middle. I use one ring at the top, one in the middle, and two at the very bottom. The two bottom rings always remain inside Section 4 for stability.