1 / 3
Ender 3 NG V1.2 | Mellow-Fly USBC ADXL345 Accelerometer Mount for BL-Touch — zdjęcie 1
1 / 3

Ender 3 NG V1.2 | Mellow-Fly USBC ADXL345 Accelerometer Mount for BL-Touch

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Mellow-Fly USBC ADXL345 mount for E3NG, designed to be rigid and not interfere with a BL-Touch bed probe.

Ocena
0 / 5
Polubienia
2
Pobrania
5
Wydruki
0
Wyświetlenia
74
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

My E3NG uses a BL-Touch that takes up most of the rear of the toolhead. I needed a rigid mount for my aliexpress ADXL345 accelerometer; the stock accel mount in the E3NG v1.2 public release collided with the BL-Touch, and the giant mess of standoffs I used to hack around it was confounding shaper results. I tried @Shobai's mount, but my umbilical mount got in the way. Therefore, I rolled my own with a few key principles:

  • This should be a drop-in replacement for the stock E3NG accelerometer mount.

  • The probe should be isolated from the main umbilical such that it can be disconnected and reconnected easily. [I don't plan to have it hooked at all times, mostly because I'm too lazy to bake it into the umbilical proper.]

  • There should be full clearance for the actual umbilical cable mount and wires.

  • The mount should not obstruct the stock E3NG BL-Touch mount whatsoever.

It's worked out thus far for me, so I figured I'd post it.

BOM:

  • 2x M3 heat-set inserts (the screw holes for the accelerometer itself are intentionally undersized to allow just tightening into plastic, but you should really use the inserts for the sake of rigidity

  • 2x M3x16 SHC screws

Tagi