Laskakit ESPink-Shelf-2.9 box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a box for Laskakit ESPink-Shelf-2.9 box https://www.laskakit.cz/laskakit-espink-shelf-2-9-esp32-e-paper/
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Simple box for https://www.laskakit.cz/laskakit-espink-shelf-2-9-esp32-e-paper/ with a switch adapter, so the devkit can be turned on and off without the need to open the box. The three poles ensure the devkit won't wiggle in the box. The USB port opening is bigger than usual so even thick USB cables will fit. The space inside can comfortably fit 103450 li-pol battery.
No screws or glue needed.
See Assembly guide for details.
Assembly guide
1) Switch adapter: push it through the top part as shown in the image, then insert the actual switch actuator through the square hole in the adapter. You may need to file it very slightly.
2) Top-bottom alignment: the two circular poles should be positioned on the side without the USB port. If you position your bottom cover other way around, you won't be able to close it as the poles will push against the switch adapter and some electronics on the board.
Print details
Top and bottom parts do not need any supports
The switch adapter needs either grid or snug supports, 0.1-0.2 mm top contact Z distance
0.2 mm layer height recommended