Casio F-91W Fitbit Air Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connector / adapter to use your Casio F-91W watch with a Fitbit Air wristband / strap
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 461
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution
This is an adapter to attach a Casio F-91W watch to a Fitbit Air wristband. The Fitbit is then worn on the underside of the wrist.
Note that this works better if you don't have a small wrist. If your wrist is too small the end of the strap will overlap with the watch. A wrist circumference of about 18cm (~7.35 inch) or larger works best.
But try it out and see how it fits, it's a quick print.
Printing
Print two Casio F-91W Air Fitbit Adapters. Print the parts in the original orientation. All model files are pre-rotated for printing.
Note: In order to print without supports this model has to be printed in an orientation with very little bed surface contact. Make sure you have good bed adhesion and/or print a bit slower than usual.
Material: PETG, PLA (you could try TPU but it's not really necessary)
Layer height: 0.2 or 0.1mm
Extrusion width: 0.45
Perimeters: 3 or more
Infill: 15% or more
Supports: no
Installation
Step 1 - Remove Original Wristband
Look through the holes on the watch case where the strap is attached to the watch case. On one side the the friction pin is thinner than on the other side. Using a pin punch tool (or equivalent), push the pin out from the side where the pin is thinner. This may take some force.
Repeat for the other side and don't lose the pins.
Step 2 - Install Adapter
Install the adapters as shown in the photos with the slot for the strap down. Secure it with the friction pin that you removed earlier. Insert the pin in the opposite direction as it came out with the thinner end forward. It should be easy to insert the pin. Only once it reaches the other side it requires some force and will click in place.
Repeat on both sides.
Step 3 - Install Fitbit
Thread the Fitbit strap through the shots in the adapters in your desired orientation. Pay attention that the Fitbit's sensors but be facing inward. Reference the photos if needed.
Remixing
STEP file is available in the Files tab.
If you woudl like to modify the part or change some of the dimensions, create a copy to edit in Onshape.
Not This Watch?
Looking for an adapter for the F-105W instead? Check out this other adapter.