Volkswagen Passat B5 / B5.5 – 1-DIN Radio & Climate Control Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Internal mounting bracket for a 1-DIN radio and climate control panel in the Volkswagen Passat B5 / B5.5.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 112
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
Volkswagen Passat B5 / B5.5 – 1-DIN Radio & Climate Control Mount
Internal mounting bracket for a 1-DIN radio and climate control panel in the Volkswagen Passat B5 and B5.5.
Designed to sit behind the centre console trim, this bracket holds the radio and climate control panel in position. The photos show the installed setup with a 1-DIN flip-out screen radio and the original Climatronic panel.
Check your console layout and mounting points against the model before printing, as different dashboard configurations may require adjustments.
Recommended print settings
These settings are a starting point; adjust them to suit your printer and filament.
Material: PETG or ASA is recommended for its heat resistance. ABS is another suitable option. Avoid PLA for permanent installation, as it can deform in a hot car.
Layer height: 0.20 mm.
Nozzle: 0.4 mm.
Walls / perimeters: 4–5.
Infill: 30–40% gyroid or cubic.
Top and bottom layers: 5–6.
Orientation: Place a large, flat face on the build plate for good adhesion and stability. Check overhangs in the slicer preview.
Supports: Add supports where needed beneath overhangs and mounting features.
Brim: Use a 5–10 mm brim if needed to reduce corner lifting.
Temperatures: Follow the filament manufacturer’s recommended profile. An enclosure is recommended for ASA and ABS.
Scale: Print at 100%. The model’s overall dimensions are approximately 190 × 135 × 62.5 mm.
Installation
Remove any supports and clean up the mating surfaces and mounting holes. Test-fit the bracket, radio and climate control panel before reassembling the console. Light sanding may be needed depending on printer tolerances.
Make sure cables have sufficient clearance and tighten fasteners carefully to avoid cracking the printed mounting points.
If you print this model, share a make with your car version, filament and print settings!