Gridfinity tool bin for the Knipex Super Knips wire cutter family - tested with 78 03 125
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
4 x 2 x 3 Gridfinity tool bin for the Knipex Super Knips wire cutter family. Deep enough to stack on top.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Gridfinity bin for the Knipex Super Knips family wire cutters. Size is 4 x 2 units and 3 units high. Knipex makes Super Knips wire cutters
78 03 125
78 13 125
78 23 125
78 31 125
78 61 125
78 71 125
78 81 125
78 91 125
of mostly the same form factor, most of them should fit (only tested with 78 03 125 though). The 78 06 125 will not fit since its grips are too large.
A PDF is included that you can print to check the outline if in doubt. Make sure to print the PDF at 100% to work correctly. Please note that the spring opens the tool a little too wide to fit the width of two Gridfinity units. So close the tool just a little when checking the fit. Also check that the grips are not thicker than 15mm if you want to be able to stack on top of the bin. See the pictures for illustration. In case your tool doesn't fit - let me know in the comments, I will publish a fitting version.
If you have a knock-off, you can also try with the PDF if it fits.
I let much tolerance for the tool, about 2 mm everywhere since I don't like to fiddle with it when putting the tool in. For some of you that might be too loose, please check with the PDF. The model shown in the photos is a prototype, the published model has more clearance below the pivot point. There is also a version with no material between the grips to save filament.
The cutout accommodates the entire height of the tool. This allows additional gridfinity bins to be stacked on top.
The versions for magnets are designed for 6 x 2mm magnets.
The basic outline was made with Tracefinity: https://app.tracefinity.net.
My printing settings:
0.2 mm BALANCED
2 perimeters
3 solid layers top and bottom
10% rectilinear infill
no support
Please see also my other Gridfinity tool bins, cases, and parts: https://www.printables.com/@trses/collections/3756947
If you use the version for magnets and want to make sure to always insert the magnets with the correct polarity, you can consider my magnet pole finder and insertion tool:
If you find my designs useful, you might consider buying me a coffee. But of course, you don't have to - my designs are free and always will be.