Home Assistant Raspberry Pi 3B Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cool looking Raspberry Pi3 case inside Home Assistant logo :) The model uses 2 colors yet it designed to be printable…
- Ocena
- 4,5 / 5
- Polubienia
- 17
- Pobrania
- 95
- Wydruki
- 2
- Wyświetlenia
- 1274
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A cool looking Raspberry Pi 3B case inside Home Assistant logo :)
The model uses 2 colors yet it designed to be printable on a single nozzle printer thanks to Z hop feature.
The model has a GoPro mount which allows mounting the case on the wall slickly.
Needed:
4x 8-16 mm M2.5
Optional if you want to use the GoPro mount:
1x M5 20mm
1x M5 Nut
I'm using Cura and here are the printing steps:
Steps
1. import "Rpi_cover.stl"
1.1. Print it with your standard printing profile.
2. import "HA_tree.stl"
2.1. Align the 'tree' model to bed upside down.
2.2. Set the model to an offset from the center in order to allow your BLtouch successfully preform the Auto Home in the next steps.
I use Bullseye with BLTouch, my offset is X: -35mm, Y: -30mm
2.3. Print!
Tree alignment
Tree alignment
3. Import "HA_home.stl"
3.1. Move it to X: -35mm, Y: -30mm
3.2. Confirm that the two model are laying on top of each other correctly
3.3. Remove "HA_tree.stl" from Cura
3.4. Enable 'Z Hop when Retracting' in Cura
3.5. Set 'Z hop height' to 0.5mm
3.6. Disable support
3.7. Replace the filament to different color
3.8. Print!
4. Optional
4.1 Print the wall mount
Category: Electronics