9x9 custom macropad case and accessories.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 9x9 custom macropad case I designed for my pcb.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Test Models
- Licencja
- Creative Commons — Public Domain
HI! This case is for a custom PCB I designed and it will have 9 customizable buttons, and a rotary encoder(for volume control).

Files:
Here are all of the files and explanations:
Start with the PCB:
Solder the MCU, diodes, hot swap sockets and rotary encoders onto the pcb
The pcb is done.
Normal case:
Files: Top case + bottom case
Start by sliding the pcb under the top case
Secure the rotary encoder on using the nut and washer(normally included with rotary encoders)
place the switches in from the top. They should be siting on the top case, with their pins in the hot swap sockets
Place headset inserts from the bottom of the top case. use 4mm headset inserts.
Slide 16mm M3 bolts from the bottom case to the top case, where the headset inserts are and tighten.
Done!

Angled case:
Files: Angled case
Install the PCB from the bottom, and secure the rotary encoder. (same was as for the normal case)
Place the switches from the top and they should be secure.
Mounted case:
Files: Mounted case parts. + top case
The mounted case parts file has to parts in it, the bottom case, and a screw.

The installation is the same. I will repeat it though just in case.
Start by sliding the pcb under the top case
Secure the rotary encoder on using the nut and washer(normally included with rotary encoders)
place the switches in from the top. They should be siting on the top case, with their pins in the hot swap sockets
Place headset inserts from the bottom of the top case. use 4mm headset inserts.
Slide 16mm M3 bolts from the bottom case to the top case, where the headset inserts are and tighten.
Now the assembly of the macropad is done, but what if you want to mount it?
For example if you want to connect it to this block, what should you do?

Slide the clamp onto the mounting surface.

Secure the screw, and tighten.

Finally, the switches.
I have designed 2 MOA profile type switches one of them is round, and one of them is square with will fillet. It's up to you which one you want.
Done! Hope everything went well
