Hole Grommet / Liner / Filament Guide 50mm across for 32mm hole
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted a grommet for the foam board enclosure I cobbled together using my foamboard clips. 50MM across, 15mm deep…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 355
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I wanted a grommet for the foam board enclosure I cobbled together using my foamboard clips. 50MM across, 15mm deep for 32 mm hole, 24mm inner diameter. Inner hole is generously radiused to avoid snags. Would work in wood other other materials as well. For foamboard, cut hole small and get a good friction fit.
Print Settings
Printer:
Anjet A8
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.015
Infill:
20%
Notes:
Support optional depending on your printer. Scale to fit your needs.
Drawn up in Autodesk 123Design - Simple, took just a few minutes.
Category: 3D Printer Accessories