Dual Scrub Daddy Sponge Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Sponge Holder
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 66
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
Remixed an original model by @ShevaCZE_3354619.
The most significant change I made is enlarging the base to fit a second regular sponge, but it could also be used as a soap rest, or something similar.
Instructions:
It's printed easily without supports. Mine was printed in PLA, in a little less than 2h, about 60g of filament. The assembling does NOT require any glue or adhesive. The fit is very very snug and tight, and it might take a minute to put together, but it should fit. If not, try to scrape of excess filament with an exacto blade, this is sometimes necessary due to wet filament or uneven printing.
Happy printing! And make sure to upload your make and give feedback (: