1 / 1
Cadder automata — zdjęcie 1

Cadder automata

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

it's a cam & gear based automata of a silly guy cadding on a laptop

Ocena
0 / 5
Polubienia
2
Pobrania
6
Wydruki
0
Wyświetlenia
81
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Sculptures
Licencja
Creative Commons — Attribution

I made this because I wanted something cool to set on my desk, and to practice my mechanical design skills. If you want to make one yourself just follow these directions:

:)

Build tutorial:

Print one of each part, plus one additional cam spacer

Assemble the walls, floor and top plate, the floor goes on the bottom, the left wall goes on the left, etc. Make sure to place the right wall so that the hole is closer to the front. Place the back wall so that the most off-center hole is on the right side.

Assemble the person on top, so that it matches this image:

Ensure the torso is facing forward, pay attention to the slot on the guy's right.

His left leg is the one that has the hole for the laptop, so put it on the left.

The arm with a simple ball joint goes on the guy's right, put it in so the end with the hole matches up with the arc on the top plate.

The other arm is the one with the peg. Put the peg in the hole.

Put the Cam shaft in the more central hole on the back plate, so that its end cap is on the outer side. Put the Crank gear beam in the remaining back plate hole.

Put the Cam spacer on the Cam shaft, and put the Crank gear spacer on the Crank gear beam.

Feed the Type arm through the corresponding hole in the top plate, then slide the Type cam (the big wheel) onto the Cam shaft, making sure to lift the Type arm above it, so that it moves up and down when you spin the Type cam.

Slide the Mouse rack into the slot on the top plate, with the pegs facing out the front.

Place the Mouse crank pin on the Crank gear beam, so that the gear part is facing outwards. Connect the rack to the Mouse crank pin using the Rack motion connector

Slide the mouse gear into the top plate, making sure the pegs are facing down. Slide it far enough that you can maneuver the other end into the corresponding hole on the floor.

Make sure to mesh the mouse gear with the rack so that when the rack is as far right as possible, the mouse gear is as far out into the top plate's slot as possible, and vice versa. make sure to shove the mouse gear's peg into the hole in the right hand.

Slide the crank-cam connector gear onto the middle gear post, with the pegs facing away from the cam wheel. Put the post in the middle floor hole, with the gear facing the back wall.

Place the Cam spacer and then the Cam gear onto the Cam shaft, meshing the Cam gear with the Crank-cam connector gear. 

Slide the Crank gear 2 onto the Right gear post so that the pegs are facing outwards (towards the wider part of the post) Take these two parts and place them in the rightmost hole on the floor, meshing the Crank gear 2 with the other two gears.

Hold the Handcrank gear against the rightmost gear, so that it is concentric with the crank hole on the right wall, then hold the Crank spacer 0.35 between the gear and the wall.

Put the Crank spacer 0.1 on the Handcrank's middle shaft, and then slide it into the right wall, through the spacer and gear.

Your automaton should now be done! You can turn the crank, and watch the guy do his CAD :)