Siglent SDS8xx VESA mount v2

Over a year ago I uploaded SDS8xx VESA mount and it works fine, but I learned a bit from it. It took too long to print because it needed a lot of supports. It was too big because it tried to enclose the whole oscilloscope, so it didn't fit on a standard printer as one model. Also it was not perfectly mated to the bottom of the oscilloscope so was less secure than it could be.

This is an effort to correct all those things, with a model that prints with no supports, can fit on a MK4S sheet, and fits perfectly. It is at least as secure as the old model. Additionally it can fit a probe rack and accessory drawers, something I intended for v1 but never got around to doing, partly because as an afterthought it was difficult to make them fit nicely. With this one I always intended for accessories to sit below so the mounting holes are provided.

Probe rack and accessory drawers for this mount

The handle for the scope hangs down below, I find this better as it does not get in the way of the lower controls or sockets. You can leave the handle off completely if you want, the scope moves just fine if your VESA arm is adjusted correctly and you push it to the side - but the handle it does make it easier to move the scope up and down.

It still takes a while to print. In PETG it seems plenty strong enough, but at least use a structural setting rather than the fastest draft possible. I used 0.25 structural, no other default changes.

Four M4 brass inserts are required to attach it to a standard VESA mount. The handle used is a standard 127mm (5") drawer pull. Pick whatever style you like, cut the included M4 bolt to fit. (Sometimes they come as very long bolts with breakaway ridges to deal with different cupboard door thickness.)

I only have a SDS804X so I cannot say for sure which other scopes fit, however other Siglent scopes may - SDS11xx and SDS10xx are strong candidates.