Accessories: Siglent SDS8xx VESA mount v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add an accessory drawer and probe rack under the oscilloscope
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 93
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a four-part print to add an accessories drawer (with two drawers) and a probe rack to the VESA mount I made for the Siglent SDS8xx oscilloscopes: Siglent SDS8xx VESA mount v2.
No supports are required during printing, if you orient the parts with the holes facing upwards. I used 0.25 Structural preset in PETG.
To add this you need to add four M3 brass inserts to the VESA mount first. If you have fitted the handle to the VESA mount then it needs to be removed before fitting these parts. The two large pieces slide together with the dovetail, then the handle is attached to this new piece. Four 16mm M3 bolts hold this to the VESA rack. The drawers just slide in and are handy for spring clips, insulating hoods, adjustment screwdrivers, whatever. Probes without clips fit into the smaller holes above, probes with clips fit into the larger holes below. I can't do much about the probe wires dangling but you can at least push them out of the way and it is better than having the probe tangling up with other things down on your workbench.
Please take a look at the video for the full process.