1 / 19
Aircon Pilipino — zdjęcie 1
1 / 19

Aircon Pilipino

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A small, wrist-worn cooler.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
19
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Gadgets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

AIRCON PILIPINO

I thought it would be nice to have some sort of personal cooling device, here in the Philippines - especially when I go outside with my wife. There are a few of these devices available for build, however mine is a little different in both structure, assembly and parts. Wear on wrist side to help cool your body through optimum blood flow!

Print:

This device's 3d parts must be printed in PETG for overall strength. As shown in the orientation photo, print the CAGE at 45° angle for maximum strength - with more than 3 walls and tree supports. Also a brim to keep the other parts down. These tree supports are easy to remove.

Tweak:

Before soldering your parts, it's is critical to ensure the Peltier module won't freeze-burn your skin. I found that setting the MT3608 module to around 7-8 volts is comfortable but you might want to go up or down (whichever is most comfortable and safest); too high will cancel out the cold side. The fan should be soldered on the MT3608 module at V+ in and V- in and the Peltier module should be soldered at V+ out and V- out. This ensures the Peltier module maintains the voltage at the set limit and the fan is continual.

Assembly:

Slide the Peltier module through the bottom of the CAGE. Make sure the letters TEC1-12706 are visible - that's the cool side that touches your wrist. Through the top of the CAGE, take a cotton swab and put some thermal grease on top of the Peltier module. Next, drop your heatsink in. Finally, place the fan in, sticker side down and pull the wires through the side hole. Finally, take some epoxy and carefully put a small amount at each corner to epoxy LID A on. Twist the wires together and pull it through the hole in the MT3608 box. Solder. Place LID B on the MT3608 box (use hot glue so you can access later). Finally, attach the 22mm wrist watch straps and plug in to your power bank.

Bill of Materials:

TEC1-12706 Peltier Module - 40mm × 40mm × 3.6mm

4010 Cooling Fan - 40mm × 40mm × 10mm

Aluminum Heatsink - 40mm x 40mm x 11mm

MT3608 DC-DC Step Up Boost Power Converter 2A

22mm wrist watch straps

10,000mAh Portable Charger

USB cable with micro connector

Thermal grease

Cage (PETG)

Lid A (PETG)

Lid B (PETG)

-----------------------

Tool List:

3d printer

Soldering iron / accessories

Multimeter

Epoxy

Hot glue gun

Screwdriver

-----------------------

Do you need an easy-build "helping hands" for this project? Try mine: The Helping Hands 2000!

https://www.crealitycloud.com/model-detail/helping-hands-2000

Tagi