CC2 Tpu Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the TPU Adpater for the Centauri Carbon 2 Combo
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 100
- Wydruki
- 1
- Wyświetlenia
- 447
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
TPU Adapter for Centauri Carbon 2 Combo
A remix of the TPU adapter for the Elegoo Centauri Carbon 2 Combo.
This adapter requires 2 × ECAS04 push-fit connectors for connecting the PTFE tubes.
Required Materials
2 × ECAS04 push-fit connectors
PTFE tube, 2 cm or longer
Installation
No modifications to the printer are required for the initial installation.
Insert the two ECAS04 connectors into the designated openings on the adapter.
Clip the adapter into place in the same way as the original Elegoo adapter.
Unlike the original adapter, there is no need to disconnect the PTFE tube from CANVAS Port 1 during installation.
Insert the additional PTFE tube into the lower connector of the adapter.
This tube can be connected to a dry box or filament dryer.
Alternatively, it can be kept short, similar to the PTFE outlet on the CANVAS, for a simpler setup.
Usage
To use the adapter:
Remove the top cover of the printer.
Disconnect PTFE Tube 1 from the CANVAS.
Insert the disconnected tube into the upper connector of the adapter.
Feed your TPU filament through the adapter.
The adapter allows TPU filament to be fed through the dedicated path while keeping the standard CANVAS setup available for other filaments.