Iwata/GSI Creos Airbrush Holder, wall mounted
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mounted airbrush holder for my Iwata (HP-C+) and GSI Creos Mr. Airbrush (PS-770) airbrushes while in use.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 36
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a way to hold either my Iwata HP-C+ or GSI Creos Mr Airbrush PS-770 while at my spray booth. For my setup it needed to be wall mounted and not clamped to the desktop and preferably not screwed into the floor of the spray booth. This was designed from scratch but heavily influenced by a store bought model that wouldn't work for my situation, adding the arm and wall mount plate for my needs.
Fits the Iwata perfectly. Because the GSI Creos has a smaller cap, it does fit a bit more loose than the Iwata but still holds it securely. The angle it is based off of is 30°.
#4 x 0.75" (qty 1) screw required for mounting plate to holder. I did snip off about 1/8" of the screw so their was no chance for it to poke through the holder inside.
#6 x 0.75" (qty 2) screws for mounting to booth side. Your size will vary depending on wall material thickness.
Printed with Polymaker PLA Pro on a Prusa Core One +
Holder:
- Printed narrow end down
- 4mm Brim
- .15mm Layer Height
- 40% Infill / Gyroid
- Organic Supports
Base Plate:
- .15mm Layer Height
- 30% Infill, Gyroid