1 / 1
XCover Pro 5 Kid Case with Bluetooth Tracker — zdjęcie 1

XCover Pro 5 Kid Case with Bluetooth Tracker

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Makes the XCover Pro 5 tough phone even more bulletproof, plus holds a credit card sized tracker.

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Very similar to my case for the Tab 7 Lite, this case is for the XCover Pro 5 business line phone, which while discontinued can be picked up cheap used. They are water resistant, durable, just a good option for kids or whomever else may be rough with a device. Of course, has my TPU bumpers. No supports, just make sure your bridging is dialed in decently well.

Print it as solid as you feel you need to. I go with 6 perimeters, 6 top and 4 bottom layers using a 0.4 nozzle.

You will need M2 heat set inserts, I used these: https://www.amazon.com/dp/B088QJG676
For the M2 screws, anywhere from 8mm to 12mm long will work.

For the tracker, the standard credit card sized ones available now for either Apple or Google, I used these: https://www.amazon.com/dp/B0HF3RFLC3

I use Polymaker Polymax Tough PLA, as it prints easy and actually holds up to impact better than any other material I've used to make these cases. Of course, can't leave it in the car in summer though. The design is for a snug fit with the phone, so you may need to scale XY slightly (make sure you match the scale rate with the bezel/bumpers/pwr button). 

For the bumper, I included the 3mf to have the modifiers and settings for Overture TPU, but you can switch to whatever TPU you want, just dial in to how squishy you want the bumper. Biggest thing of note on the bumpers is to make sure the anchor section is solid, either through infill, perimeters, or a million bottom/top layers. Any bumper fits any slot in any orientation. Use standard tricks for minimizing oozing with TPU. Print each bumper sequentially, or on their own print. Make sure your TPU is dry!!!

Power button likely needs a small brim to keep it from breaking loose from the bed.

The hole where the tracker goes, I use a hydrophobic PTFE membrane sticker for growing mushrooms to cover it from the inside: https://www.amazon.com/dp/B09LD119PF
This lets the maximum amount of volume from the tracker out, but keep spills and debris out of the case.