Scout's Begode Master Rear Handle and Bumper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Rear bumper and Handle for the Begode Master series of EUC's that both looks good and protects from falls.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't like that all the options for Begode Master rear handles/bumpers were either bad looking, were too long, too short, or were paid files, so I made my own. And now anyone else with a Master can enjoy it too.
I didn't like how much the Grizzla rear handle extended so far outward that it looked back heavy, and even with modified suspension it still had overkill clearances for protecting from falls. This should still give the same level of protection but with better visuals and less filament to make.
This was primarily designed with Sirayatech TPU-GF, and the 3MF file should have the settings that I used for it and the file oriented correctly (It requires no supports). For those not using the 3MF, here are the recommended print settings:
(((Please note that I'm using a 0.4mm nozzle, so if you are using a different size, the wall count will need to be calculated to match these thicknesses)))
TPU-GF (67D):
- 0.4mm nozzle or larger
- 3-4 wall loops
- Alternate extra wall
- 5 Top Layers
- 5 Bottom Layers
- 20% Infill (TPMS-D, TPMS-FK, Gyroid, Cross-Hatch)
TPU-95A (UNTESTED):
- 0.4mm nozzle or larger
- 6 wall loops
- Alternate extra wall
- 6 Top Layers
- 6 Bottom Layers
- 22% Infill (TPMS-D, Cross-Hatch)
Screws needed:
- 4x M4x24
- 2x M5x25