Endorphin Stage 3 - Broke Boy Version
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Don't wanna pay for an all new extruder and hot end to finish out your endorphin build? Look no further.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 56
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
After upgrading my hot end to a volcano style, I didn't want to repurchase a new hot end, let alone the new extruder motor that the Endorphin stage 3 requires because, well I am broke.
This design reuses everything you should already have. The part fan will probably need to be cut down to fit around your hot end. On my Ender the toolhead is ASA whereas everything else is PETG. 4-5 walls 30-50% gyroid infill, once imported auto orient IIRC only the part fan needed support. I don't have any issues after 100 hours printing on this set up. Prints ASA-GF in its enclosure perfectly.
There are two holes on the side for a Mellow Fly adxl, just thread the M3 bolt into the plastic. I wouldn't recommend leaving it attached during printing.
To strengthen where the belt attaches I added holes to thread m3 bolts into. You can see those in the IRL photos.
I finished and printed this a while ago so some holes might not have been the right size and are needing to be drilled out.
I would also recommend adding two washers as spacer between the hot end heat sink and the plastic. Pretty much everything threads into plastic, so don't over tighten things.