Anemometer for Raspberry Pi
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Anemometer for a raspberry pi.Use either a Hall effect or Reed Switch hot glued to the side via the opening the body.…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 611
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other 3D Objects for Learning
- Licencja
- Creative Commons — Attribution
Anemometer for a raspberry pi.Use either a Hall effect or Reed Switch hot glued to the side via the opening the body. Hot glue a neodymium magnet onto the threaded rod.
Requires:
2 x 608z bearings
5 x M8 nuts
3 x washers
Threaded Rod
The main body can be screwed down. This was one feature I wanted, the ability to screw the Anemometer to the roof of an allotment shed. Cups are push fit into the center ring. You could either super/hot glue or PLA weld the cups into place.
Unsure on RPM. When tested with a drill bolted to the threaded rod one cup flew out at a very HIGH RPM.
Build guide coming soon via Instructables.
Category: Learning
Print Settings
Printer:
Da Vinci Jr
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20%