1 / 4
Ninja Pods and Grounds Coffee Maker Auto Filler lid — zdjęcie 1
1 / 4

Ninja Pods and Grounds Coffee Maker Auto Filler lid

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lid for the ninja pods and grounds coffee maker that holds a float valve

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
24
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

This is specific to the current Ninja Pods and grounds coffee maker, it should work for all models.  it is used with this https://www.amazon.com/dp/B0F1DGX52R valve setup to tap into the fridge water line to feed water to the coffee maker as well so you never have to suffer with no water in the maker.   my voron is very well tuned and was calibrated for dimensional accuracy but variations in printers may make this not fit or be too loose.  it needs to be snug  so the float does not push the lid up over time and then fills your kitchen with water.  these float valves use pressure from the water pushing up on the float to close the valve.   I am probably going to drill the top edge of the water container and lid to insert  a couple of M2 screws so that it will not just push off.   the screrw holes would be so high that even if you did not like this the water container will be left unaffected.  I made sure to put a shutoff valve at the lid just in case.     

You need to install the valve loosely and without the line connection first and put the lid on the coffee maker to make sure it is oriented properly to clear the walls and can move completely and easily. then tighten down.   once you put the elbow on it will be not easy to disassemble again.  you dont have to go nuts tightening anything as this doesnt sit under water. just need to keep it from moving.

I wish I could find a higher quality valve of this size but I was unable to find any.

Tagi