Hozan JIS (Japanese Industry Standard) Magnetic Screwdriver Holder, 3, 4, 5mm Holes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This block magnetically holds the 4-piece set of JIS screwdrivers. Could hold other brands as well.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 20
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Instead of wondering "where did I put that screwdriver", They are all in one place. This is designed for the Hozan JIS screwdrivers which two are 5mm in diameter and one each 4mm and 3mm. A little about JIS. While the Philips screwdrivers do not always fit right and can cam out with pressure, the JIS will fit better and rarely cam out. They are the best screwdrivers that I have found. They are available on Amazon.
The block works using two 4mm x 8mm long Neodymium magnets per hole. The magnets are put in repelling each other keeping the screwdriver hole fully open. When the screwdriver is inserted, the magnets attract to the screwdriver shaft and hold the screwdriver in place. The cover is slid over each set of magnets at a time since the repelling magnet will try to pop out. Use two M3 x 6mm countersunk screws to fasten cover. If you have screwdrivers larger in diameter, try using more walls when printing and drill the holes out larger. You may also need to use shorter magnets.
I used Creality Burnt Orange PLA filament, 0.15 layers, 3 walls, 20% infill