1 / 3
Ubiquiti AirCam Dome G1 to G3 Flex camera shim mount — zdjęcie 1
1 / 3

Ubiquiti AirCam Dome G1 to G3 Flex camera shim mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Rather than remove old Aircam Dome G1 screw mounts, this shim allows a G3 Flex to be mounted directly in the hole with…

Ocena
0 / 5
Polubienia
0
Pobrania
10
Wydruki
0
Wyświetlenia
371
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution

Rather than remove old Aircam Dome G1 screw mounts, this shim allows a G3 Flex to be mounted directly in the hole with easy adjustment.

The base has the same bayonet mounting ears as the G1 allowing a drop-in replacement in a few minutes. The mount also has a downward collar to give the G3 some weather protection, although not as much as the official 'skins' available now.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Yes

Supports:

Yes

Notes:

Print with the bayonet fittings towards the bed with supports.

Be careful not to snap the ears off when removing the support material - mine worked fine with 3 out of 4!

Post-Printing

The original was a little tight on the G3, so the polygon count was increased to make the interior more circular.

Depending on your printer, some sandingmight be required, or tweak the internal diameter in OpenSCAD (aircam_od parameter)

Category: DIY

Tagi