1 / 5
Lamp holder for T8 shaped LED tube lights — zdjęcie 1
1 / 5

Lamp holder for T8 shaped LED tube lights

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Designed this to convert a T8 LED tube that replaces a Fluorescent lamp into a free standing LED tube. Any length tube.

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
40
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Quite a few years ago I bought a bundle of T-8 60cm/2ft fluorescent lamp shaped LED lights. Most of them I used to convert fluorescent fittings in the intended way. 

When I decided that there had to be a light above the bathroom mirror, I remembered that lamp and it sort of fit the bill of a linear shape LED. I tested it by just hot wiring both ends with 230V (do NOT try this, it's dangerous!). I liked it and over time redesigned it. First I quickly drew up end-caps in FreeCAD (source file included) and they worked out very well, also because I used a Chamlet/Chamfillet so it doesn't cause problems while printing flat on the build plate.

However the holder became a longer project. I did draw something up in FreeCAD and even printed it, but I wasn't quite happy with how flimsy it ended up being and didn't like the look.
As I'm currently exploring OnShape, I decided to give it another go with that. I went with a simpler geometry and was able to leave room inside for a full size mains cable. I drilled a hole into the back of the aluminium extrusion, fed the cable through and soldered it carefully to the LED power supply (If you decide doing this, make sure to fix the insulating sleeve in place with glue and attach the ground wire reliably to the extrusion!).

This worked out perfectly and is now installed and the cable is not visible from regular positions.

The models and description are provided as-is and without any warranty. This should only be attempted by someone who understands how to do this in a compliant way with applicable rules and regulations. Use something like I did: PETG-V0, which is flame retardant, just in case.
It should work for any length T-8 lamp, but might require more than one holder.

Here's the OnShape Document for the holder. I ended up redesigning it in OnShape as an exercise.

For reference, that's how the specific LED extrusion/lamp end looks like in its original form:

Tagi