Bottom Lid for Mac Mini A1347 2014
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A drop-in replacement for the missing, worn down or broken part
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 23
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
A lid for the Mac mini A1347 2014 I made as an effort to upcycle a small batch of devices from a recycling centre.
This is different from 2012 and 2010 models, despite sharing the same Axxxx model number.
Printing advice in case you decide to use stl instead of prepared 3mf:
Orient by letters facing down. It will leave very nice surface finish
Use snug supports on build plate only, to ensure the nice finish of the walls
Put support blockers on the Mac mini wording (Photo 4). It should (crtm) print fine.
Rotate/direct the flow of the infill (or the model itself) so that it goes in parallel with the word directio. Although I couldn't influence it anymore in Orca for some reason?
And yes, print with somewhat flexible plastics. PLA and PETG are ok.
Once printed, bolt fixers need to be somewhat developed - put the lid on and off before letting it settle. Use some sort of a prying tool with the tape on it to avoid damaging surrounding aluminium.
Feel free to stick some furniture pads underneath, why do that tho?