Ryobi Link Rail keyed for small print bed, Split with Interlocking Joint
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
RobC’s Ryobi LINK accessory rail split into two small-bed sections with a keyed joint that resists pulling apart.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 25
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a small-bed remix of RobC’s “Accessory Rail for Ryobi Link” v4. The rail is supplied as left and right STL files. Each section fits on a Creality Ender 3 V3 KE bed; assembled, they retain the original rail’s 274 mm overall length.
I also added a model where the full "RYOBI LINK" name appears like in the original from Ryobi.
Print the STLs in their supplied orientation, with the long direction along the bed and the narrow 23 mm edge down. PETG is recommended. A 5–8 mm brim can help steady the parts; supports should not be needed. Clean any brim or elephant foot from the joint before checking its fit.
Fit the keyed ends together, then secure both sections through their original mounting holes. The joint resists lengthwise separation, while the mounting fasteners keep the sections seated. Do not use the joint by itself to support hanging tools.
This remix has been checked as a 3D model but has not yet been physically test printed. Please check the fit and mounting before putting it into service.
Original design: “Accessory Rail for Ryobi Link” v4 by RobC. This remix is shared under the original CC BY-SA 4.0 license.