Bowdabra-like Bow Maker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of another Bowdabra bow maker. I use rubber bands and M3x10 screws
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print one base, one ruler (if desired), one fly - to push the bow material together, one end cap, 2 BladeUR-LL, 2 BladeUL-LR and assemble. Print in the orientation shown in the 3MF file. Use 4-M3x10 screws to hold everything together and 2 medium rubber bands to make the blades come together. The endcap fits VERY tight - a touch of light sand paper or removing some material with a hobby knife may be necessary - depends on how bad your printer "elephant foots" the first layer. Put the rubber bands in the channels in the bottom of the blades and insert into the base - align the chamfers so the very middle looks like an X with all four blades installed. Install the end cap and secure with 2 screws, then push the blades tight against the end cap and install one screw in each to secure them. I printed the ruler plate in white and used a Sharpie to make the numbers and marks stand out (still haven't upgraded to multi-material)