Apple HomePod Mesh
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 3d printable replacement mesh for your Apple HomePod! 1st Gen currently supported. 2nd Gen will be added soon.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 53
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Is your Apple HomePod's mesh looking bad? Maybe you just want to add some flare?
There are two "versions"; One single-piece tall version that slides over the original mesh...and a two-piece split version that you glue together. A third version will be added soon intended for you to remove the original mesh entirely and replace it with your own printed version of choice.
There are different "densities". Mid-fine in my opinion looks closest to the original, doesn't affect the sound like fine can, and still covers the original mesh enough to obscure original dinge. Coarse should in-theory affect the sound even less, but comes at the cost of showing more of the original mesh through.
The standalone version allows a ~2mm gap on the bottom to alow the HomePod's original rubber base to retain it's grip.
If you choose the split version, I would suggest printing the bottom half "upside-down" and adding a small ring to it to be printed in TPU, otherwise your pod will be sitting on plain plastic and slide around easier. I've included a .3mf of the bottom half with a ring added via object modifiers in my slicer.
I would recommend only attempting to print the first few layers to tune your settings. Default, these can take at least 10-20 hours print, but you can get that down to under 8 hours with proper tuning and profiling, w/o needing supports. Included is the config I use to print the standalone version on my snapmaker u1 in about 6 hours with impressive results.
Check back as I add more versions and flesh out the description. I am eager to hear any feedback, tips, ways to improve print time / quality etc. If you successfully print this in a soft TPU / foam TPU let us know!!!
UPDATED 27/9/2026: Fixed mesh poking through bottom and cord border bleeding over on split version
