Wall-Mounted Kitchen Shears Holder — Diamond Lattice & Drainage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall-mounted kitchen shears holder with diamond lattice, draining base and two countersunk screw mounts.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do not auto-orient this model onto its sloped end. I tried that and it did not print nicely. No supports or brim needed.
===
Keep your kitchen shears accessible with a compact wall-mounted holder!
The open diamond lattice reduces material use and lets air circulate around the blades. A sloped mesh bottom drains through small diamond openings, with a row of half diamonds directly against the inside back wall so water can escape at the lowest edge.
Two countersunk screw mounts, spaced 50 mm apart, help prevent the holder rotating on the wall. Matching front access holes let you reach the screws with a driver. The back has flat contact rails and a reinforced central mounting strip.
You could also mount this with command strips!
DIMENSIONS
- Clear opening: 40 mm wide x 17 mm front to back.
- Internal height at the back: 115 mm.
- Internal height at the front: 98 mm.
- Overall size: 44.8 x 23.8 x 122.8 mm.
- Mounting centers: 30 mm and 80 mm below the opening, centered across the width.
HARDWARE
- Two #6 flathead screws with countersunk heads or a command strip
- Front driver-access holes: 9 mm diameter.
PRINT ORIENTATION
Import at 100% scale and keep the supplied orientation: the rectangular opening goes flat on the build plate, with the long walls vertical and the sloped closed end at the top. Do not auto-orient this model onto its sloped end. I tried that and it did not print nicely.
The latest version was printed in black SUNLU PETG. No supports or brim needed.