1 / 1
Pocket Hole Clamp Wall Holder (Dragonite 11" / Kreg-style) — zdjęcie 1

Pocket Hole Clamp Wall Holder (Dragonite 11" / Kreg-style)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Wall holder for two Kreg-style pocket hole clamps: store them clamped on, with a forgiving self-centering pocket.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
22
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution

Pocket Hole Clamp Wall Holder (Dragonite 11" / Kreg-style)

A wall holder for two right-angle pocket-hole clamps. There are no hooks or cradles. You store each clamp the same way you use it: drop the pin into the pocket, set the pad on the bottom face and lock it. The clamp stays locked on the wall, so it can't fall off.

Designed for the Dragonite 11" 2-in-1 Pocket Hole Clamp. It should also fit other Kreg-style right-angle pocket clamps with an 8 mm pin.

Features

  • Forgiving pocket: it flares wide at the opening and narrows smoothly into an exact 9.8 mm seat. Aim roughly and the pin slides into place by itself.

  • Compact: two clamps in a 75 × 95 × 30 mm part, held by 3 screws.

  • Reinforced where it counts: hidden internal slots make the slicer print the area between the pocket and the pad nearly solid, with no modifiers or special settings needed.

  • Test coupons included: one with this pocket, and one with a plain drilled-style pocket for comparison.

Hardware

  • 3 × 4 mm countersunk wood screws, The two lower screws pass through the 30 mm blocks.

Check your clamp first If you have a different clamp, print a test coupon (about an hour) before the full holder. It should lock at close to your normal 3/4" setting.

Remixing

  • .py (Fusion script): the easiest way to change dimensions. Every one is named at the top, including pin-to-pad distance, block width, spacing, screw length, pocket flare and reinforcement. Paste it into a new Fusion script and run it in an empty design.

  • .f3d and .step: also included, but they're a direct export and don't rebuild when you change a dimension.


Recommended print settings

  • PETG (PLA+ works, but can creep under long-term clamping).

  • Print lying on its back, pockets facing up. No supports.

  • 3 wall loops. Infill and everything else can stay at your defaults.

  • Keep "Remove all holes" (Cura) or any similar option off. The internal reinforcement slots have to stay in the model.


Why not just drill a pocket hole in a block of wood?

You can, and it works. If you have scrap and a jig handy, go for it. Printing it gets you a few things wood doesn't:

  • The pin finds the hole easily. A drilled pocket is a narrow, sharp-edged slot, and hitting it one-handed while holding a heavy clamp is fiddly. The printed pocket flares wide and guides the pin into the seat.

  • It doesn't wear out. Repeated clamping slowly crushes wood, especially end grain under the pad, and the pocket gets sloppy over time. PETG keeps its shape.

  • Easy to adapt. Changing one number in the script re-fits it for a different clamp, board thickness or screw length.