Tarot 650 16mm slide-in arm clamp
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A much better arm mount for the Tarot 6 series UAV/UAS platform 600 650 680 and sport classes.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 24
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- GNU General Public License v3.0
If you have one of the Tarot 6xx series UAS then you probably have some form of their clip-on arm mounts or worse; those old pass through blocks with the tabs.
These aim to solve the problem of wiggling arms by cinching the block into the arm as you tighten the leading bolt. The holes are offset by about 0.5mm so that as you snug it all up tight it really grabs the arm.
This is not going to entirely drop your noise floor for tuning but you're going to see a significant reduction in low frequency harmonics especially during take off and sustained hovers at-load.
You'll need 8x 30mm M3 bolts and M3 Nylon locking nuts.