Ball Corral Ramp

When you have a lot of balls to recollect when the game is done, wouldn't it be nice to be able to just roll them in one spot and have them be neatly stashed for later? This model is broken up into several pieces that can be assembled to form the structure. 

What should be printed for the full thing: 

2 "Side Wings"

2 "Knockback Plates"

2 "Side Panels"

3 "Bottom Ramp Panel x3"

1 "Bottom Ramp End Panel"

2 "Connector Rails"

2 "Inverted Connector Rails"

1 "Corner of Top Rail"

2 "Top Rail (Handle) x2"

1 "Top Rail"

1 "Corner of Top Rail Inverted"

2 "Handle x2"

Once all pieces are printed attach pieces as follows:

-connect the 3 bottom ramp panels with bottom ramp end panel attached on one end

-next take the 2 side panels and put them on opposing sides attaching them on the peg on the long side of the panel.

-from there, put the 1 "top rail" down in the center, and connect the 2 top rail (handle)s with one on each end of it

-then take the 2 corner of top rails on the ends of that connection and make sure all connections are firm between pieces

-you should now have 1 long rail that you can attach to the notch on the top of both side panels

-with both of those in place, you can now take the 2 connector rails, along with the 2 inverted connector rails and insert them into the side panels so that one set of outward facing pegs point away from each other, and the others point to each other.

-take the pair facing each other and put one of the knockback plates on each so that make a straight chute

-lastly put the side wings on the pegs facing away from one another and the handles on the last connection on top of the top rail

confirm that the pieces assembled match the picture provided.