Parametric tablecloth corner clip & table corner protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Parametric corner clip that keeps your tablecloth in place while protecting sharp table corners. Ez adjustable in Fusion
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 32
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I designed these corner clips to keep our tablecloth from sliding around on the table. As a bonus, they also cover the sharp corners of the tabletop, which is especially useful with small children around.
The upper and lower arms are 3 mm thick and angled inward by 2°. This gives them enough flexibility to slide over the tabletop while still providing some spring tension to keep the tablecloth in place.
I went through three printed versions to get the balance right. Thinner walls and a steeper angle provided more clamping force, but also made the arms much easier to break. The current 3 mm / 2° version has worked well for me. You could go for 2mm clamp thickness for more flexibility though.
The ready-to-print model is made for a 30 mm thick tabletop.
Different tabletop thickness?
I've included the original Fusion 360 (.f3d) file. The design is parametric: simply change the tableTopHeight user parameter to the thickness of your tabletop and the model will adjust accordingly.
I recommend leaving the 3 mm arm thickness and 2° clamping angle unchanged unless you specifically want to experiment with the amount of clamping force.
Parameters
tableTopHeight — Adjust this to match your tabletop thickness.
If you must:clampThickness — Tested at 2 mm. Changing this affects flexibility.clampAngle — Tested at 2°. Changing this affects clamping force.
Print settings
Material: PLA
Wall loops: 4
Supports: Yes
Orientation: See included screenshot
Ready-to-print tabletop thickness: 30 mm
Print the model in the orientation shown in the screenshot. Supports are required in this orientation. I use 4 wall loops to give the flexible arms enough strength while still allowing them to flex around the tabletop.
Update - October 6, 2026
After using the clips for a while, I found that the 2 mm version was a little too flexible and could eventually break under constant tension.
I've updated the model with 3 mm thick arms for improved durability. I also changed the parametric design so that tableTopHeight now represents the minimum clearance at the tips of the clamps. This means changing clampAngle no longer reduces the specified tabletop clearance.
The updated ready-to-print model has a 30 mm clearance and uses a 2° clamp angle.