Prusa i3 MK3S Y carriage camera holder for LSC 3215672 cameras
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Camera holder for the Prusa i3 MK1, MK2 and MK3 family of printers. Wont fit the MK4's updated Y carriage.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 41
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Got an LSC wireless camera in Action for 9.95€ and thought it would make a good Prusa Connect camera for my MK3S.
After having the firmware sorted out (to bypass the Tuya / LSC cloud), I noticed that the ball joint is held on the camera's factory stand by a small screw. Below is the stand withouth the ball joint:

To print the stand, I used Prusament ASA - 0,20mm SPEED preset without supports and with brim. The supports are built-in to the model, don't forget to remove them when the print is finished. After printing use the original screw to attach the ball joint to the holder arm and slide the arm onto the front left or right part of the Y carriage.
You can find more info on how to de-cloud the camera here:
THIS ONLY APPLIES TO THE LATER VERSION OF THE CAMERA WITH PRODUCT NUMBER 3215672.2
https://github.com/themactep/thingino-firmware/discussions/1043 (look for the lsc_camera_3215672.2.zip in the discussion)
https://github.com/berobloom/LSC-1080p-Anyka-Decloud
Here's a guide how to setup a Linux service to upload snapshots from any RTSP video stream to Prusa Connect:
https://github.com/AttilaSVK/rtsp-to-prusa-connect
You can run this on your Raspberry Pi Zero alongside PrusaLink.