The Mourning Lantern

The Mourning Lantern is a gothic hooded figure cradling a carved jack-o’-lantern. Flowing robes meet a broad circular plinth, creating a silent guardian for your Halloween display.

Curious about making your own designs? Have a look at Infillery’s creative tools.

What’s included

• One optimised STL, upright and ready to slice

• Single connected, watertight part with its flat base at Z=0

• Approximately 69 × 69 × 150 mm at the supplied scale

Printing

• Print upright on the supplied base

• 0.4 mm nozzle; 0.20 mm layers

• 3 walls/perimeters; 15–20% infill

• PLA or PETG

• Start with supports disabled, then inspect the sliced preview

Notes

The hood edge, pumpkin carving and deeper robe folds contain short bridge and overhang regions. Review these areas for your printer’s cooling performance.

The production STL was inspected as one manifold part with zero open or non-manifold edges. A Bambu Studio A1 slice with the 0.20 mm Standard profile and supports disabled completed successfully: approximately 8 hours 27 minutes and 52.7 cm³ (about 65 g) of PLA. These are slicer estimates.

The supplied 150 mm size is the recommended starting point. Scaling down may reduce detail in the fingers, pumpkin face and cloth. Re-check wall thicknesses, bridges and overhangs after resizing.

Licence and attribution

Original design by Infillery Originals. Please follow the licence displayed on this listing, including its attribution and non-commercial conditions where applicable.

More from Infillery

Explore original designs, customisation and licensing enquiries at https://infillery.com.

Printed this model? Share a Make. We would love to see your filament colours and finish.