1 / 5
INCRA T-Track Story Stick System – Marking Flags, Offset Flags & Calipers — zdjęcie 1
1 / 5

INCRA T-Track Story Stick System – Marking Flags, Offset Flags & Calipers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This custom story-stick system takes inspiration from the Woodpeckers design, using INCRA T-Track Plus rails with flat m

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
16
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This custom story-stick system takes inspiration from the Woodpeckers design, using INCRA T-Track Plus rails with flat marking flags, bridged offset flags, caliper arms, and 3D-printed end stops.

The flags were laser-cut from transparent orange cast acrylic, nominally 3 mm thick and measured at 2.8 mm. M6 brass thumbscrews, square sliding nuts, washers, and compression springs provide adjustable clamping with light preload. Acrylic joints were solvent-welded using Plastic Weld #3 cement for PMMA, applied with a fine syringe while tweezers maintained alignment.

The shared SVG includes one of each flag assembly, with separate cut and score lines. The accompanying 3MF includes matching components and the end stop. Printed flag components require assembly; print at 100% scale and verify fit before producing additional units. Mirror the caliper arm to create its opposing partner, and disable the SVG’s annotation group before laser cutting.

Tagi