eSun Vacuum Pump3 stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stand for eSun Vacuum Pump, Pump does not rest on seal and does not fall over even if cord hangs over edge of workbench.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This is a stand for the eSUN Vacuum Pump. The documentation that came with mine calls it the "Electric Vacuum Pump3."
With this design, the pump doesn't rest on its silicone seal and won't tip over, even if the power cord hangs over the edge of the workbench.
I first tried Jens' model at https://www.printables.com/model/442952-stand-for-esun-vacuum-pump, but my pump didn't fit. I was inspired by his design but started fresh.
The center post fits into the center of the pump. Although it's not a tight fit, it's snug enough to hold the pump upright. The post is tall enough to keep the silicone seal suspended, helping to prevent deformation.
The "crenellations" (raised areas) on top provide clearance for features on the bottom of the pump body and allow the vacuum intake port to sit between them. This helps the pump sit more securely on the stand.
The example shown here was printed in PLA on a Prusa MK4 using a 0.4 mm nozzle and a 0.2 mm layer height.