Precise M4 HEX NUT T SLOT for 2020
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an M4 hex nut T-slot for a 2020 extrusion. The ender 5+ 2020 aluminum profile was used for this.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 12
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Standard Digital File License
This model is extremely precise because it is printed slightly large, and then the process is to push it through your aluminum profile. The profile will shave the excess plastic off and there you will have a perfect fit. Insert Tina into the profile by by wiggling it in allowing the plastic to shaved off . After you are about a millimeter or two deep, you can bang the aluminum profile onto a desk or something or use a hammer. That will push the plastic through the profile and shave it on the way in. Do this for both sides and then put an M3 screw into the nut and move it around until it's smooth if you need it to slide.
Prints recommendations
-Print with the teardrop hole pointing upwards as shown in the picture.
-0.4 or even better 0.2 mm nozzle recommended.
-Print at least four nuts at once so that each top surface gets time to cool down
-Print slow, maximum of 65mm
-Your slicer should allow for walls as small as 0.2 mm even with a 0.4mm nozzle.