1 / 3
La Cerradura Doble - sliding key puzzle — zdjęcie 1
1 / 3

La Cerradura Doble - sliding key puzzle

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

La Cerradura DobleThis is a remake of a puzzle I've seen online: http://smallpuzzlecollection.blogspot.de/2011/11/la-…

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

La Cerradura Doble

This is a remake of a puzzle I've seen online: http://smallpuzzlecollection.blogspot.de/2011/11/la-cerradura-doble.html. The original puzzle was limited series only and is long sold out, but I figured out from a photo how it went together and decided to remake it to have a try at solving it.

I have not invented the puzzle itself, however the printable 3d-CAD design (including all the engineering that went into making this printable from opaque plastic) has been made by me.

printing and tolerances

If your printer is accurate, the puzzle will be smooth in operation and there will be a gap of 0.2mm between the lid and the base. Since the top layer is slightly rough always, the gap will pretty much be closed by the imperfections of the top layer. If your printer is a bit out of whack as far as extrusion goes, you might need to put M2 washers between the lid and the base on each screw.

The whole thing is designed with 0.2mm gap round about moving parts, and all sliding parts slide along layers, so it should operate rather nicely. The biggest fun killer is if your corners of the base part lift-off.

Print in contrasting colors (lid and keys different color from base and sliders), else it's an eye strain to figure out what gets locked by what.

The puzzle itself:

get both horizontal keys out of the system and then put them back. To achieve that you will have to move the five vertical sliders and move the keys in proper order. The keys are different from each other and fit as pictured (round corners to the outside). Have fun.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Mk2

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%


Notes:

You will need 5 allen bolts M2x8 and 5 M2 hex nuts to put this thing together.
The lid has to be printed upside-down (laying flat on its top). No supports needed.

Category: Puzzles

Tagi