1 / 4
Robot Vacuum Barrier for Tubular Furniture Legs — 16 / 20 / 25 mm — zdjęcie 1
1 / 4

Robot Vacuum Barrier for Tubular Furniture Legs — 16 / 20 / 25 mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A zip-tie-mounted barrier for horizontal furniture tubes, designed to discourage robot vacuum climbing. Untested prototy

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
10
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Robot vacuums can climb onto low horizontal furniture tubes and become stuck. This barrier is designed to add a taller vertical surface that the robot's bumper can encounter before climbing onto the tube.

Designed for straight, round, horizontal tubes on chairs, tables or similar furniture.

Included sizes:

• 16 mm tube diameter

• 20 mm tube diameter

• 25 mm tube diameter

Choose the STL that matches your tube's outside diameter. Each version includes 1 mm of diametral clearance.

The default barrier length is 120 mm and the body height is 45 mm. Installed height above the floor depends on the tube diameter and its distance from the floor.

The OpenSCAD source allows adjustment of tube diameter, clearance, barrier length, body height and zip-tie tunnel dimensions.

PRINTING

Print in the supplied orientation: flat face on the build plate, open groove facing up.

Suggested starting settings:

• PLA or PETG

• 0.2 mm layer height

• 3–4 walls

• 15–20% infill

The transverse tunnels require short bridges. Check the slicer preview before printing.

INSTALLATION

After printing, flip the part so the groove faces down and place it over the furniture tube. Thread two plastic zip ties through the transverse tunnels and around the underside of the tube.

Zip ties are required and are not included. There must be enough space beneath the tube for them. This version is unsuitable for tubes resting directly against the floor.

Check that the barrier is secure and cannot rotate. It must not support the furniture's weight. A short barrier may leave other sections of a long tube exposed.

PROTOTYPE STATUS

This model was created with AI assistance using OpenSCAD. It has not yet been physically print-tested or tested with a robot vacuum.

The images are CAD illustrations. The tube, feet and orange zip ties shown in the assembly image are illustrative and are not included in the STL.

Compatibility depends on your furniture and robot's bumper height and obstacle-crossing behaviour. Supervise the first cleaning test.

Feedback, print photos and results with different robot vacuums are welcome.

Tagi