UGREEN PB536 Power Bank Gridfinity Cradle – 4×2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 4×2 Gridfinity cradle for the UGREEN PB536 power bank with large finger openings & relief for the built-in USB-C cable
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This Gridfinity cradle was designed for the UGREEN PB536 20,000 mAh power bank.
The power bank lies flat in a shallow, loose-fitting tray. Large openings make the heavy power bank easy to lift, while an additional corner relief accommodates its built-in USB-C cable/lanyard.
The fit intentionally has some clearance rather than gripping the power bank. Its weight keeps it stable in the drawer, and the extra room makes removal easier.
Features
4×2 Gridfinity footprint
Pocket approximately 154 × 73 mm
Designed around a 152 × 71 × 29 mm PB536
Low 3 mm walls
Large finger openings on every side
Relief for the built-in USB-C cable/lanyard
No magnets or screws
Prints in the supplied orientation
No supports required
Tested print settings
Printer: Original Prusa i3 MK3S
Material: SUNLU Matte PLA
Nozzle: 0.4 mm
Layer height: 0.30 mm
Infill: 10%
Supports: None
Orientation: Flat, as provided
Notes
This model was physically tested with my UGREEN PB536. The fit is intentionally loose and may also accommodate small dimensional variations between units.
The Gridfinity base geometry was generated using kennetek/gridfinity-rebuilt-openscad, based on the original Gridfinity system by Zack Freedman. The underlying library is MIT licensed.