Sword & Knife Display Stand – One-Piece, Support-Free
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One-piece, support-free display stand for cosplay swords and knives – a wedge slot keeps the blade upright.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Costume Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
A simple display stand for cosplay swords, knives and other blade props. The blade stands edge-down in two forks.
What makes it special: the slot is wedge-shaped and follows the blade's cross-section, so the blade stands straight instead of wobbling:
At the edge: 3 mm
2 mm above: 6 mm
20 mm above: 17 mm
(Includes 0.5 mm clearance per side – designed for a fabric-wrapped blade measuring 2 / 5 / 16 mm.)
Thinner blades will fit as well, they just sit a bit deeper. For thicker blades the slot needs to be widened.
The model prints completely without supports: all overhangs are at least 45°, the arch has a flat bottom, and the feet use an A-frame shape instead of a round cutout.
Dimensions: 208 × 110 × 80 mm, 200 mm between the forks. Fits comfortably on 250 × 250 mm print beds.
Print settings
Material: PLA or PETG
Layer height: 0.2 mm
Walls: 3
Infill: 15 %
Orientation: upright, as it stands
Supports: none
Brim ( you should enable it , or print it slow when your bed moves)