Dual Sensor Apex Extruders for NightOwl
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Apex Extruders with Prep and Load sensors embedded for use in NightOwl
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 198
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is the Apex extruder introduced with BoxTurtle v1.1. Hardware in the extruder is the same, with the addition of one more D2HW switch and MR63ZZ bearing.
Follow print and configuration settings from the original link here: https://www.printables.com/model/1606168-apex-extruder-for-boxturtle-11
To install this in your NightOwl, print one set of files mirrored. You will also need to invert the dir_pin on one lane. The included bottom plate is needed to mount the extruders. The extruders are angled towards the hub to improve the filament path.
Combine this with my other NightOwl mods:
Filamentalist FV3 Respoolers: https://www.printables.com/model/1577021-nightowl-filamentalist-fv3-mod
BoxTurtle v1.1 Hub/Buffer combo: https://www.printables.com/model/1864558-boxturtle-v11-hub-for-nightowl
BarfTurtle LEDs: https://www.printables.com/model/1864612-nightowl-leds-for-lane-indication
Smol v2 (HGX 2.0) extruders (dual sensors): https://www.printables.com/model/1865219-dual-sensor-smol-v2-hgx20-extruders-for-nightowl