HGX Lite extruder with dual filament sensors ala LGX Lite
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a modification to my LGX Lite dual switch spring conversion to use a $13 HGX gears instead of Bondtech LGX gears
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 201
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- GNU General Public License v3.0
2026-10-13: the camlock only works well with a spring. it is not consistent without it. Perhaps a curved disk spring would be lower profile.
2026-10-10:
Added a camlock file. The center cross threaded pin is steel in the picture. Difficult to find, you can try to thread directly into a printed one. This is not the classiest solution, but it was just a proof of concept. It works just fine without a spring.
Added a mid part for use with the included ECAS fitting in the HGX kit. Untested.
2026-10-06: Updates
1:Added a low profile lever.
2:Fixed back cover.
3:Replaced strain EBB36 max clearance mounts with 1mm longer ones from LGX spring conversion model.
4:Added a long lever. 4 to choose from now. Needs a cam action lever in the future!
5: updated the step assembly
Check my LGX Lite dual filament model for more info on how to assemble this for now. More info to come.
This model uses the same lever and front cover as my LGX Lite Spring Conversion + dual filament switch model.
This model uses cheap HGX gears from Amazon. You must get the gears that come with ball bearings for the idler gear and needle bearings for the two filament gears. The one used for this project had the title of: "Precise Double Drived Gear Extruder Gear Set for HGX-LITE-extruder Hardened Steel Extruder Driver Gear Set"
Amazon Link: https://www.amazon.com/dp/B0FD3XDJMK
Switches: https://www.amazon.com/dp/B0DJMH615K
Notes:
Now installed on a V0, and extruding plastic like a champ. The HGX version works great. Clamps onto TPU like a vise.
The HGX kit has a pin for the bottom hinge, a 25mm bolt can be used here, but you also have the option of drilling out the insert and using the included pin.
some assembly pictures have been added. I find it essential to put some scrap prints on the sides and press it together before final assembly to fully seat the pins.
If you downloaded an early version of this, make sure you have the latest update of the back cover, it should have a 1mm bump on the idler gear side.
dont use screws that are too long on the bottom, they will bind the gears up. 5-6mm for the front two screw holes on the base. The rears can and should be quite long if you end up using them.