Mario 3D Customizable Display Diorama with Interchangable Pieces

Interchangeable sliding puzzle to create your own Mario scene with pop-out art. Mix, match, and rearrange to keep the scene new and different. Includes

• Characters - large Mario, Koopa, Bullet Bill, along with  small Mario and Spiney (models included but not shown in picture). Newly added Petey Piranha!

• Scenery - Brick, Question Box, and 2 sizes of Tubes.

• Frames - Three options: Snap together parts, a 5 x 6 box, or a 5 x 7 box.

• Tiles - two sided, smooth and with hold for two sizes of pegs to attach character.

Printed using QIDI 2 with white PLA. The grids require 30 tiles for small and 35 for large boxes. In the painted picture I used spray paint for the tiles and miniatures paint for the characters and scenery.

Tips:

• If using the snap together box assemble carefully to avoid posts snapping, best to connect a top and bottom then an extender (x2) and then bring the two together evenly.

• Puzzle box requires a lot of the single block tiles, consider printing multiple at a time or combining to form 2x2 pieces.

• Assemble the desired design with box flat and then raise so the blocks create a tight fit that hold it together despite gravity.

• Its best to slide tiles into place so there is no forcing or friction when pushing tiles in.

• Tiles are two sided to show a smooth blank side or the side with a hole for two different sizes of posts to connect the characters and scenery with depth. Just connect a peg and then the character or scenery.

• Holes can be added to the Corner box pieces to hang on the wall.  

I hope you enjoy and plan to add more character models soon.

Disclaimer. Fan art. Characters and designs are intellectual property of Nintendo. Personal, non-commercial use only.