Dashboard Stand for LEGO 75436 The Mandalorian & Grogu’s Speeder Bike
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rotating stand for LEGO set 75436 "The Mandalorian Speeder Bike". No LEGO parts needed.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution
Dashboard Stand for LEGO 75436
The Mandalorian & Grogu’s Speeder Bike
I saw someone build a swivel stand using a few LEGO bricks. I’m sure we have those parts somewhere in the house, but rather than sacrifice them to the dashboard sun god, I decided to print a stand instead.
This simple stand replaces the brick base and support rod. It uses the existing hole underneath the speeder, so no additional LEGO parts are needed.
The speeder rests on the shoulder of the stand and can rotate around the pin. How freely it moves depends on the printed fit, surface finish and mounting angle.
Features
60 mm diameter base with a flat underside for double-sided tape.
3.2 mm mounting pin.
Prints upright without supports.
Tested
Printed on an Elegoo Neptune 4 with a 0.4 mm nozzle in both PLA and PETG. Both prints fit my model perfectly.
Fit may vary between printers and filament profiles. The speeder should slide onto the pin without force and rotate freely. Remove any stringing or rough spots before fitting.
Suggested print settings
Print at 100% scale; dimensions are in millimetres.
0.16 mm layer height.
4 walls.
5 top and bottom layers.
25% infill.
No supports needed.
Dashboard use
Fit has been tested in PLA and PETG; long-term PLA heat resistance on a dashboard has not.
Keep clear of airbags and the driver’s view. The speeder rests freely on the pin and is not locked in place.
