1 / 9
Strap Mounting Replacement for Decathlon Forclaz Trek 900 Headlamp — zdjęcie 1
1 / 9

Strap Mounting Replacement for Decathlon Forclaz Trek 900 Headlamp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement for broken or lost part

Ocena
0 / 5
Polubienia
1
Pobrania
18
Wydruki
0
Wyświetlenia
39
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Needed to quickly make it to end the cheapoo Decathlon struggle.

Fully reverse-engineered, and somewhat improved replacement for the headlamp strap holder/adapter. Thicker than the original, the same otherwise.

  • PETG or better. PLA must be avoided outdoors, plus it wears down faster, and this lamp depends on friction fit a lot.

  • Print in the same orientation as shown on Photo 3

  • Supports for central inners, either normal snug or tree work. Try avoiding supports on holes and bump cuts. Refer to 3mf or the last two photos. Support can be avoided altogether but I didn't want to yolo it.

  • 100% infill, better do it.

  • Do not take it out of the printer immediately if you're using enclosed setups. It will warp. Let it cool down first. A1 folks you're good.