Wifi Reflector Antenna
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wifi Router is on one end of the apartment. Office is on other side. With coronavirus making us all WFH it was time to…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 28
- Wydruki
- 0
- Wyświetlenia
- 748
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Wifi Router is on one end of the apartment. Office is on other side. With coronavirus making us all WFH it was time to improve wireless connection with a reflector that wasn't as ugly as (but not performant as) my earlier cardboard corner reflector.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
Yes
Supports:
Doesn't Matter
Resolution:
0.3mm
Infill:
5%
Filament: Octave ABS Black
Notes:
Raft if making in ABS.
Print and cover the inner curved face with metal. I used Aluminum tape. Place behind wireless router if it's near a corner, and it will improve the quality of the signal. Scale as needed. A cutout was made for a bookshelf. I made it a little too high and therefore the reflector sits a little low relative to the router, but it gets the job done without being too intrusive.Post-Printing
Make it an Antenna
Add metal to the curved face. Aluminum tape, aluminum foil and tape, anything conductive. Use command strips or whatever to affix to corner.
How I Designed This
OpenSCAD was used, the file is included.
Created 2-D cutout of roughly what I wanted, then did a linear extrude. I also made a cylindrical cutout to save on material and weight.
Two sections were put together for my bookshelf.
Category: Electronics